Other or General Questions
Frequently Asked Questions
- Can someone give me the procedure on how to check if your spindle is worn or not.
- Dimensional and Surface Location Errors in CUTPRO.
- How do we set microphone gain? We have -10dB and -20Db switch on the microphone and CUTPRO gain is set to 1.
- How do you select impact hammers and accelerometers?
- Since the measurements with accelerometer and hammer is obtained without any machining process (without tool touching the workpiece), whether the workpiece setup and workpiece holder has any affect on the machine dynamics. If they have any effect, then how it can be incorporated into the stability lobe calculation?
- What is the influence of work material on the chatter?
- With regard to tool geometry in some cases we have tools with different helix angle or serrated and continuous flutes and other variations which are not given has input to the software. So whether these parameters have any effect and if they have any effect on machine stability how are they incorporated into the software?